Engine, Clutch, Transmission and Hydraulics

Topics

• Another way to find top dead center

  0 Tue Jun 10, 2014 9:53 am

• How to remove and install new valve guides

  0 Mon May 05, 2014 8:21 pm

• Carberetor cleaning / rebuild "How-to"

  5 Sun Feb 23, 2014 5:18 pm

• Transmission Spline Replacement

  3 Tue Oct 15, 2013 9:24 am

• New T/C Filter UPDATED

  2 Tue Apr 30, 2013 10:42 am

• Wear Sleeve Installer

  0 Sat Jan 19, 2013 10:00 pm

• Reverse Idler Gear Bushing Replacement

  1 Sun Dec 16, 2012 12:33 pm

• Touch Control Rockshaft Repair

  0 Thu Dec 01, 2011 11:45 am

• NO PILOT SHAFT HANDY?

  0 Mon Nov 07, 2011 1:51 pm

• Head Bolt Drill Guide

  0 Wed Nov 02, 2011 3:13 pm

• How To Adjust Clutch Fingers

  5 Sat Oct 08, 2011 7:22 pm

• Clutch Adjustment Through the Hand Hole.

  0 Tue Aug 02, 2011 9:11 am

• Home Made Small Engine Air Filter Housing

  0 Thu Apr 14, 2011 8:19 pm

• How To Remove Oil Pressure Relief Valve

  0 Tue Nov 30, 2010 9:51 pm

• Cleaning & Resurfacing the Head and Pistons on a Kohler 301

  0 Sun Oct 10, 2010 6:38 pm

• Plastigauge: What it is--How to use it.

  0 Wed Oct 06, 2010 8:10 am

• How To Change A Head Gasket

  0 Sat Jun 05, 2010 7:25 pm

• Changing Oil Bath Filter Oil Cup

  0 Thu Dec 10, 2009 9:39 am

• How To Rebuild A Cub Transmission

  0 Sat Nov 28, 2009 7:03 pm

• Touch Control Fill Plug - Extension

  0 Fri Nov 27, 2009 9:24 pm

• Motor Oil, ZDDP and Yesterdays Engine - Part 3

  0 Sat Oct 17, 2009 8:38 am

• Motor Oil, ZDDP and Yesterdays Engine - Part 2

  0 Sat Oct 17, 2009 8:38 am

• Motor Oil, ZDDP and Yesterdays Engine - Part 1

  0 Sat Oct 17, 2009 8:38 am

• How To Adjust Valves

  0 Tue Aug 18, 2009 9:33 pm

• How To Properly Remove a Crank Pulley - Method #2

  0 Sat Aug 15, 2009 12:17 pm

• How To Rebuild a Touch Control Pump

  0 Sun Aug 02, 2009 2:05 pm

• Inspection & repair of a Governor

  0 Fri Jul 31, 2009 9:42 pm

• Hydraulic Block Rebuild

  0 Thu Jun 11, 2009 3:18 pm

• lapping valves, (with pictures)

  0 Wed May 13, 2009 8:18 pm

• Tranny 101 or How a Dummy Repairs a Broken Fork!

  0 Mon May 11, 2009 9:23 pm

• How To Restore a Manifold

  0 Mon May 04, 2009 9:46 pm

• How To Install Threaded Inserts in the Transmission Case

  0 Mon May 04, 2009 4:17 pm

• How to install Vertical Exhaust

  0 Sun Mar 22, 2009 2:58 pm

• Repowering a Cub Cadet 782 with a Honda Engine

  46 Sun Mar 22, 2009 10:27 am

• Go to page: 1, 2, 3, 4

• Slickerin' up yer underslung

  0 Mon Feb 16, 2009 7:40 pm

• How To Make a Replacement Clutch Inspection Hole Cover

  0 Fri Jan 09, 2009 6:10 pm

• Homemade Cylinder Ridge Reamer/Cutter

  0 Fri Nov 21, 2008 4:26 pm

• No bore gage - no problem!

  0 Sat Sep 27, 2008 5:49 pm

• Replacement front crank seal

  0 Sun Aug 31, 2008 7:43 pm

• How to properly remove a crank pulley

  0 Sun Aug 31, 2008 7:23 pm

• Touch Control Rebuild

  0 Mon Aug 04, 2008 9:23 pm

• Hydraulic Adapter

  0 Mon Jul 07, 2008 9:17 pm

• Corky's How-To Rebuild a PTO

  0 Sun Jun 22, 2008 10:27 pm

• DIY Clutch Alignment Tool

  0 Tue Jan 29, 2008 9:56 pm

• How to measure engine cylinders

  0 Fri Nov 30, 2007 12:24 pm

• Stuck Valve - unsticking - mildly stuck

  0 Wed Sep 19, 2007 7:37 pm

• Vacuum Gauge - an engine diagnostic tool

  3 Mon Sep 17, 2007 7:56 pm

• How To Remove A Reluctant Pilot Bushing From The Crankshaft

  0 Sun Aug 05, 2007 6:53 pm

• altered plan

  0 Mon Jul 30, 2007 8:23 pm

• How To Remove A Siezed Exhaust Pipe From The Manifold

  0 Thu Jun 28, 2007 6:37 am