Farmall Cub Forum -- Questions and answers to all of your Cub related issues.
Moderator: Team Cub
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Since you have the head off the engine, remove the valve tappet cover located on the left side of the engine. Check for valve tappet clearance. There is a section in the service manual and perhaps the operator's manual on adjusting valve tappet clearance.
Then, as you rotate the engine by hand to lift one valve at a time, inspect each valve face and seat for seating and damage.
I have an excuse. CRS.
So I tore down the cub engine, removed and cleaned and lapped all the valves and oiled the guides, re installed, adjusted the lash... put it all back together.... cranked and cranked and cranked.... nothing...
Today I decided to replace the carb with one off of my running tractor... Then instead of cranking the engine over by hand I pulled it with our JD and after a few yards she began to smoke and roared to life. I had no oil pressure showing up on the gauge so I shut it down and pulled the cover off of the oil filter housing and it was full so the pump is working.... just a bad gauge.
After the pull start she began firing up with the crank handle and she is purring like a kitten. Tomorrow I am mounting the cultivators... After at least three years setting a nother one springs back to life.
I have never understood why Cubs will start when pull started but will be difficult as the dickens no matter what you do to start them. Ellie did that to me after sitting for 6 months and Granny did the same thing after sitting idle for a couple years. Not sure why ... is it because of the higher rpms when pull starting
Who is online
Users browsing this forum: Dale Finch and 11 guests