3d printable IH float level gauge

[butchs38]

For all those that have access to a 3d printer here are float drop and height gauges for cub IH carb. https://www.thingiverse.com/thing:2872919

[Steve Butram]

I will give it a shot. I own a share of a 3D printer

[Gary Dotson]

Steve, I thought about You & Ryan when I first saw this post. Print one and bring it to Portland, so we can check it out.

[Dale Finch]

Steve, I thought about You & Ryan when I first saw this post. Print one and bring it to Portland, so we can check it out.

...or print a handful, add a chain and sell them at a cubfest as keychains!!

[butchs38]

if someone can send me this dimension i will make one for the zenith https://ibb.co/cehQdc

[Steve Butram]

Got mine when I went to lunch today. Thanks for the download

[Dusty B]

Don't have access to a 3d printer but I like Dale's idea! How expensive are they to produce?? Dusty B

[Urbish]

You should put these up on Shapeways. Then people could order them if they don't have access to a 3D printer.

[butchs38]

shapeways would be about $10 US actual material cost is 19 cents and 37 minutes to print. A cheaper alternative is to upload the file to https://www.3dhubs.com/ and have it printed with petg layer height 200um would be around $5.

[outdoors4evr]

Zenith measurements: 15/32" Fuel Level (with Gasket in place) 1 & 5/32" Float Height

[butchs38]

thanks but i need to know the width from inside edges where the gasket sits and thickness of gasket