heres pictures of clutch, can ya tell if its any good? what should i look for?
any way motor dropped off at the overhaul place.
rear axle/torque tube on trailer (easier to move around), front end outside to be blasted.
john
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
clutch
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
- John(videodoc)
- 10+ Years
- Posts: 6547
- Joined: Mon Jul 25, 2005 10:16 pm
- Zip Code: 61944
- Tractors Owned: -
55 F-Cub - snow plow and chains
3 Demonstrators Restored.
"Bette" - 22 mower
"Roxie" - 144 Complete Cults'
"Sandy"(Done) 193 Plow
1950 Demo, "Billie"
-(Woods 59")
Corn Stalk Cutter
23a Disc
&
2005 Mahindra w/FEL - Circle of Safety: Y
- Location: IL, Paris just off of Interstate 70
- Contact:
-
- Team Cub Mentor
- Posts: 20336
- Joined: Fri Jul 02, 2004 9:52 pm
- Zip Code: 65051
- Circle of Safety: Y
- Location: Mo. Linn
The machine shop will remove the pressure plate, clutch disk and flywheel during disassembly. They will be able to tell you their condition.
The pressure plate and flywheel should be ok. Check the condition of the wearing surface of the pressure plate fingers.
Clutch disk. It's probably going to be replaced.
Be sure to install a new throwout bearing.
Whow - that's one funky looking engine.
Eugene
The pressure plate and flywheel should be ok. Check the condition of the wearing surface of the pressure plate fingers.
Clutch disk. It's probably going to be replaced.
Be sure to install a new throwout bearing.
Whow - that's one funky looking engine.
Eugene
Who is online
Users browsing this forum: Majestic-12 [Bot] and 23 guests