Page 1 of 1
cultivator rear gang piece
Posted: Thu Nov 09, 2006 6:27 pm
by meandmydeere
Would anyone have dimensions for the piece that attaches to the lift arm that picks up the rear cultivator gangs? I need to fabricate one since I lost mine.
3/4 hot rolled cross piece with a welded ear that attaches to the lift arm via 2 bolt holes.
Thanks, Mark
Posted: Thu Nov 09, 2006 6:46 pm
by Don McCombs
Mark, maybe you can work out something with Brandon Webb that's easier, cheaper and quicker than making one.
http://www.farmallcub.com/phpBB2/viewtopic.php?t=16492
Posted: Thu Nov 09, 2006 6:50 pm
by Rudi
Mark:
This is the lifting bracket for the rear rockshaft that the lift rods attach to. Is this the part you need?
Lifting Bar Assembly
Posted: Thu Nov 09, 2006 7:57 pm
by Jim Becker
At some point, they changed to a thicker bracket. I don't know off hand if 3/8 is the thin or the thick.
Posted: Thu Nov 09, 2006 8:01 pm
by Rudi
Jim:
I am not sure what Revision this is.. I will have to go have a look.. maybe there is a part # somewhere, but it is the original I got from Dave and Alton. Apparently it was off of an earlier version.. but who knows.. It does work well.
Posted: Tue Nov 14, 2006 11:49 am
by Don McCombs