I'm in the process of rebuilding an IH standard carb with an IH rebuild kit #354 454 R92 that Lynn sent to me last week. Per instructions carb dissasembled, cleaned, dewarped
, and started assembly. Came time to install choke shaft
dust seals and seems like they are to large for my carb
. The new seal caps are the same as the single throttle shaft
seal cap which did fit (supposed to be correct?). The new measure 7/16" and the old choke shaft
cap 3/8", and actually fits inside of the new cup. Carb # as best I can see with my loop is #251234 R? and looks like another stamp to the right of the R# but defaced from PO tapping on cover at some time. I'll try to post a few pics on this post if I can figger it out. (no excuse for not knowing by now
) Has anyone else had this problem before?, wrong carb kit?,oddball lower half? I guess I'll have to wait to talk to TM until 10/02 but hopefully can get some input from the board first....if everyone is not at JPs'