Page 1 of 1
Poplarville Implements
Posted: Sat Dec 20, 2003 12:31 pm
by Bigdog
It looks like I may have inadvertently deleted the update on Poplarville implements. Sorry!
My disk has the number CL 5092 as a serial number. I believe Russ said his was CL 4001. I'm guessing the model number must be CL. There was no mention of model on the tag.
Posted: Sat Dec 20, 2003 2:34 pm
by Harold R
Mine has "CL" and the number 3430. "Equipped with Genuine Maremont Blades". Would be nice to get a photo and some info.
HR
Posted: Sat Dec 20, 2003 7:00 pm
by rleggitt
Thanks Guys,
I will be e-mailing tomorrow and perhaps calling monday. I sure hope they
come up with some info. I would like to know the specifics such as what type blades as mine needs replacing.
I don't know about the ones you guys have but mine surely cuts better than the fast hitch IH model that I have.
Will pass along anything I glean.
Posted: Sat Dec 20, 2003 7:15 pm
by Dan England
Where is the serial number located on the disk? I would like to check mine. Thanks Dan
Posted: Sat Dec 20, 2003 7:36 pm
by Bigdog
There should be a stamped plate riveted to the left side of the upright on the tongue. If you look close, you should be able to see it in this picture:
Poplarville Implements
Posted: Sun Dec 21, 2003 3:42 pm
by Dan England
I checked my disk this afternoon and discovered that it, too, is a Poplarville implement. The serial number is CL9177. I had not heard of this company before the post by Harold saying his was a Poplarville brand. Dan
Posted: Thu Dec 25, 2003 4:37 pm
by John *.?-!.* cub owner
This Ebay item looks like a drawbar to go with a Poplarville disk. It's located about 35 miles from me.
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=11756&item=2583228966
Posted: Wed Dec 31, 2003 4:46 pm
by George Willer
John,
I bid on that drawbar for Marilyn's Cub and won, and after sending payment I got thinking about Bigdog's picture of his disk and scrolled back to see it again. I then found your link to the item. I now suspect you were one of the other bidders. Do you have a need for the Poplarville crossbar?
I was thinking to use it to make up a mounting for a harrow I have, but could do it another way.