Switch to full style
Farmall Cub Forum -- Questions and answers to all of your Cub related issues.

Forum rules

Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Post a reply

Front Wheel bearings

Fri Dec 26, 2003 4:24 pm

I am putting new tires on one of my 49 Cubs and pulled the outer bearing and one of the needles in the bearing is gone. I want to remove and repack both front wheels but I'm not sure how the hubs come off. Does one pop the back of the hub with a hammer , use a puller or what?
Any help is appreciated. By the way , I don't contribute to the forum much but I read and enjoy it nearly every day. keep up the great work.
Elmer.

Fri Dec 26, 2003 4:46 pm

Elmer, per the GS-1411 manual:
Image

Or..

Fri Dec 26, 2003 8:01 pm

Or you could use a bearing splitter :idea: .

If you don't have one (I'm guessing you don't :?: ), you can either buy one, or rent one.

You can pick up an offshore-made one at most auto parts stores for less than $10, which is probably what it would cost you to rent one anyway.

Front Wheel bearings

Sat Dec 27, 2003 10:19 am

Thanks for the help. I havent worked on the hub yet but it evidentily just pulls off the inner bearing & grease seal. I had two 480-12 6 ply rating tires & tubes mounted since the air was starting to show through on the old ones. I thought the 6 ply might hold up better with the heavy blade.
Thanks again, Elmer.

Sat Dec 27, 2003 3:06 pm

if you need to remove and replace the bearing races from the hub, installing the new ones is a snap if you take the old race and grind the outside a bit. the object is to make the old race small enough to slip into the hub easily. you then use this modified race to drive the new one home. one of gramp's 'special' tools :!: :)
Post a reply