Farmall Cub Forum -- Questions and answers to all of your Cub related issues.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Mon Dec 29, 2003 1:04 pm
Hello, I have to change my front oil seal. I need some advice on pulling the crank shaft pulley. I see there is also a bushing in there . Should this be replaced as well.
Thank you, Dave
Mon Dec 29, 2003 2:02 pm
I think the bushing (sleeve) will come with the seal if you get it from a case IH dealer. Most come off hard. Don't pull from the edge of pully or it will break the pully. A bearing seperator from a cheap tool supply place like Harbor Freight will work good. Soak with your favorite penetrating oil and it may come off but if it don't leave it alone awhile and tighten more. If all fails you will need some heat. I cannot get anything to come up in the archives on this board but there are lots of post on the other Cub board. http://www.atis.net/cgi-bin/FarmallCub.pl
Do a search there.
Mon Dec 29, 2003 4:38 pm
something i copied a while back from Tim in CA. has a JC Whitney puller #81UJ2372T... 39.99. http://www.jcw.com
looks like i'm needing one for the '48 cub. it's starting to drip like an old faucet.....so's the radiator
Mon Dec 29, 2003 5:07 pm
Art, take a short 1/2-13 bolt and drill a divot in the head. Thread it into the shaft and use the puller against it.
Mon Dec 29, 2003 5:45 pm
I cannot tell if that JC Whitney job is big enough are not.
Wed Dec 31, 2003 4:04 pm
Thanks all, Have a New Year!
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.