Shaft repair???
Posted: Sat Jan 10, 2004 3:40 pm
Would it be possible to build up the differential shaft and axle shaft where the seal rides with say JB Weld & then turn it back down to the correct size? Is JB Weld tough enough to withstand the seal riding on it or will it wear a groove in it quickly? I checked into Redi-sleeves at our local auto parts store, but aside from the fact that you have to sell your body parts to pay for them, they can only get 3 of the 4 sizes I need. The shafts are not real bad but need some attention.
One member on this board suggested machining the shaft to clean it up and then taking the spring out of the seal and shortening it some to put a little more pressure on the shaft.
Is their any other method other than flame spraying, I could use to fix this?
Any & all comments are welcome. Thanks.
One member on this board suggested machining the shaft to clean it up and then taking the spring out of the seal and shortening it some to put a little more pressure on the shaft.
Is their any other method other than flame spraying, I could use to fix this?
Any & all comments are welcome. Thanks.