I need (4) piston wrist pins for a 1948 60 cubic inch Farmall CUB. I can't seem to buy any except in a complete engine rebuilding kit, which I don't need. Does anyone know where they can be bought??
I need help guys!! Thanks.
Sheila
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Piston Wrist Pins
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- 10+ Years
- Posts: 1
- Joined: Sat Jan 17, 2004 8:54 pm
- Location: Palm Desert, CA
- Bigdog
- Team Cub Mentor
- Posts: 24144
- Joined: Sun Feb 02, 2003 12:50 pm
- Zip Code: 43113
- Circle of Safety: Y
- Location: OH, Circleville
- Contact:
Try Jamie at J.P. Tractor Salvage - http://www.jptractorsalvage.com or Tom at T.M. Tractor - http://www.tmtractor.com One of them should be able to fix you up.
Bigdog
If you can't fix it with a hammer, you've got an electrical problem.
My wife says I don't listen to her. - - - - - - - - Or something like that!
http://www.cubtug.com
If you can't fix it with a hammer, you've got an electrical problem.
My wife says I don't listen to her. - - - - - - - - Or something like that!
http://www.cubtug.com
-
- Team Cub Guide
- Posts: 3543
- Joined: Sun Feb 02, 2003 6:30 pm
- Zip Code: 38658
- eBay ID: Cub-Bud
- Tractors Owned: Four FCUBs, one IH Lo-Boy, one B Farmall, two Cadets, and a John Deere B.
- Circle of Safety: Y
- Location: MS, Pope
Piston pins are available from Case/IH. The part # is 251241R2 and they cost about $10.00 each. The bushings in the connecting rods should be replaced if new pins are used. They will need to be pressed in and then reamed. Have a machine shop do this if you are not able. The bushings are also available from Case/IH. The part # is 251247R1 and they cost about $5.00 each.
"Never forget where it is you come from, or you may find yourself someplace you don't want to be"
Greg Norman
Greg Norman
Who is online
Users browsing this forum: No registered users and 25 guests