Farmall Cub Forum
Moderator: Team Cub
I was missing something... The second picture shows things better.
If it were me I'd send it to George
One thing to keep in mind was that the deluxe seat didn't come along until the Fast Hitch was available. On the Farmall Fast Hitch, the rockshaft is mounted in the 2 large castings that bolt to the final drives.
The LoBoy Fast Hitch mounted where the old style rockshaft mounted but also on the right axle housing. So it raised both sides of the seat bracket. By the way, the standard seat on the LoBoy used the two upright brackets of the deluxe seat.
It is possible that IH said you couldn't use the deluxe seat with the old style rockshaft. More likely, they had some 1/2" spacers to put under the right bracket. I have never seen the installation instructions for a rear rockshaft that was dated '55 or later. If somebody could find one of them, it would most likely answer the question.
If it was my tractor, I would put some 1/2" spacers under the right seat bracket. If that proved to be uncomfortable, I would make a new left bracket from scratch, 1/2" inch shorter. Its, flat steel with one 90 degree break, not that hard to do. Then you still have the original bracket for when you take the rockshaft back off.
BINGO! I just may have something I can use in the scrap pile. Thanks!
Who is online
Users browsing this forum: frederick and 10 guests