Throw out bearing
Moderator: Team Cub
2 posts
• Page 1 of 1
Throw out bearing
by Jon-boy » Tue Jan 20, 2004 1:42 pm
I have a new throw out bearing where the hole is 1 1/4" and the shaft is 15/16" since I don't have a parts manual can you tell me is their is a bushing that will make up the difference? Thanks..
- Jon-boy
- Posts: 11
- Joined: Tue Jan 13, 2004 4:16 pm
- Location: Palo Cedro, CA
by George Willer » Tue Jan 20, 2004 1:57 pm
Jon-Boy,
That's normal. There is no bushing. The TOB is located by the yoke that carries it. Don't forget to put the zerk to the bottom so you can grease it. I just found one assembled upside down. I'm sure it was never greased.
That's normal. There is no bushing. The TOB is located by the yoke that carries it. Don't forget to put the zerk to the bottom so you can grease it. I just found one assembled upside down. I'm sure it was never greased.
George Willer
http://gwill.net
The most affectionate creature in the world is a wet dog. Ambrose Bierce
http://gwill.net
The most affectionate creature in the world is a wet dog. Ambrose Bierce
-
George Willer - Cub Pro
- Posts: 7011
- Joined: Sun Feb 02, 2003 9:36 pm
- Location: OHIO, Fremont
- Zip Code: 43420
- Circle of Safety: Y
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: Bob Triplett, GenrlCub, Kirk-NJ and 4 guests
|
|