This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Throw out bearing
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
Jon-boy
- 10+ Years
- Posts: 11
- Joined: Tue Jan 13, 2004 4:16 pm
- Location: Palo Cedro, CA
Throw out bearing
I have a new throw out bearing where the hole is 1 1/4" and the shaft is 15/16" since I don't have a parts manual can you tell me is their is a bushing that will make up the difference? Thanks..
-
George Willer
- Cub Pro
- Posts: 7013
- Joined: Sun Feb 02, 2003 9:36 pm
- Zip Code: 43420
- Circle of Safety: Y
- Location: OHIO, Fremont
- Contact:
Jon-Boy,
That's normal. There is no bushing. The TOB is located by the yoke that carries it. Don't forget to put the zerk to the bottom so you can grease it. I just found one assembled upside down. I'm sure it was never greased.
That's normal. There is no bushing. The TOB is located by the yoke that carries it. Don't forget to put the zerk to the bottom so you can grease it. I just found one assembled upside down. I'm sure it was never greased.
George Willer
http://gwill.net
The most affectionate creature in the world is a wet dog. Ambrose Bierce
http://gwill.net
The most affectionate creature in the world is a wet dog. Ambrose Bierce
Who is online
Users browsing this forum: jobbyjim and 12 guests
