Apparently you have to cut the welds on the sleeve to replace the bearings. Anyone have any experience with this procedure?
Thanks
Jack
Anyone service a woods 42C mower spindle?
Moderator: Team Cub
3 posts
• Page 1 of 1
Anyone service a woods 42C mower spindle?
by Mamachala » Fri Jan 30, 2004 7:43 am
'48 Cub - Babe
'54Cub - Louise
'50 Super A - Annabelle
'55 JD 50 - Thelma
'54Cub - Louise
'50 Super A - Annabelle
'55 JD 50 - Thelma
-
Mamachala - Posts: 45
- Joined: Fri Jan 30, 2004 7:39 am
- Location: Salem, Ohio
- Zip Code: 44460
by artc » Fri Jan 30, 2004 8:39 am
jack, i'm not familiar with that mower, but if you take a look on Rudi's manual site, you'll probably find the info. http://www.cleancomputes.com/Cub/index.html
Welcome to the forum
Welcome to the forum
'If they're tappin', they're not burnin'
http://www.ZagrayFarmMuseum.org
http://www.ZagrayFarmMuseum.org
-
artc - Cub Pro
- Posts: 1641
- Joined: Sun Mar 30, 2003 10:25 am
- Location: CT, Middletown
- Zip Code: 06457
- eBay ID: cmtelephone
- Tractors Owned: 1950 cubs (3), 1948 cub, 1941 A, 1948 H, 1963 B414, 1958 240U, 1948 Oliver 60 industrial, Oliver 70 industrial.1948 super AI (basket case), 1958 450.
by Mamachala » Fri Jan 30, 2004 8:58 am
Yes, the Woods manual says to just buy a new spindle assy., $220.00. Thought I could save alot of money by just replacing the bearings and seals, and wondered if pthers have had any luck doing this.
Thanks
Jack
Thanks
Jack
'48 Cub - Babe
'54Cub - Louise
'50 Super A - Annabelle
'55 JD 50 - Thelma
'54Cub - Louise
'50 Super A - Annabelle
'55 JD 50 - Thelma
-
Mamachala - Posts: 45
- Joined: Fri Jan 30, 2004 7:39 am
- Location: Salem, Ohio
- Zip Code: 44460
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: Brendan In NC, FCub S. E. Tn, Lurker Carl, ScottyD'sdad, Winfield Dave and 9 guests
|
|