Farmall Cub Forum
Fri Feb 06, 2004 7:49 pm
how tight should i tighten the drawbar bolts, also are all the bolts the same length,
Does any one know if the 47 cub with a hand lift , will the pto have to be turning if i add on a hyd. lift for the lift to work my 8-n is like like that my 61 cub i can use lift when the pto is off thanks
Fri Feb 06, 2004 8:03 pm
Don't know torque settings, but I always used TIGHT. Yes there are different lengths depending on what you are attaching. Too long a bolt can break through teh casting into the final drive gear area resulting in aan oil leak.
All the cub hydralic systems drive off the motor, so the pto does not have to be running, unless you are adding some type aftermarket.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.