Need help with a bracket for #54 snow blade
Tue Feb 17, 2004 9:57 pm
I hope someone can help me with a problem. 
I just purchased this blade and am needing the bracket that bolts to the torgue tube of the tractor just behind the starter. This is not a 54A blade, but the one that came just before the 54A. I have the arms that extend down from this bracket to where the blade mounts. If someone can give me the dimensions and the bolt hole center dimensions I think I can make the bracket. Appears to be just flat stock 8 to 10 inches long. The bracket appears in the photo courtsey of TM tractors.
Thanks for any help.
I just purchased this blade and am needing the bracket that bolts to the torgue tube of the tractor just behind the starter. This is not a 54A blade, but the one that came just before the 54A. I have the arms that extend down from this bracket to where the blade mounts. If someone can give me the dimensions and the bolt hole center dimensions I think I can make the bracket. Appears to be just flat stock 8 to 10 inches long. The bracket appears in the photo courtsey of TM tractors.
Thanks for any help.
Tue Feb 17, 2004 10:06 pm
Dan; T M tractor supply now sales these brackets in there used parts directory under replacements parts for 11 dallors (stock # 39gb-416)
Wed Feb 18, 2004 2:23 pm
Thanks to Donny, and everyone else that responded I now have a bracket fabricated and the #54 blade installed on the tractor in addition to the center mount blade that was already installed. I think they will/should work together pretty well. 
The snow accumulation that we have had on the ground for the past month has just about all melted right now though. 
The snow accumulation that we have had on the ground for the past month has just about all melted right now though.