Farmall Cub

I hope someone can help me with a problem. I just purchased this blade and am needing the bracket that bolts to the torgue tube of the tractor just behind the starter. This is not a 54A blade, but the one that came just before the 54A. I have the arms that extend down from this bracket to where the blade mounts. If someone can give me the dimensions and the bolt hole center dimensions I think I can make the bracket. Appears to be just flat stock 8 to 10 inches long. The bracket appears in the photo courtsey of TM tractors.




Thanks for any help.

Dan; T M tractor supply now sales these brackets in there used parts directory under replacements parts for 11 dallors (stock # 39gb-416)

Thanks to Donny, and everyone else that responded I now have a bracket fabricated and the #54 blade installed on the tractor in addition to the center mount blade that was already installed. I think they will/should work together pretty well. The snow accumulation that we have had on the ground for the past month has just about all melted right now though.