Need measurement from lo-boy

[Daniel H.]

I'm still playing with adapting the Allis-Chamlers gear box to the cub to slow down and reverse the PTO but I need to know the distance from the center of the PTO shaft to the inside of the left (viewed from rear) fender to see if I have enough clearence. Since my cub is in pieces I can't measure it. Thanks!

[George Willer]

Daniel,

It should be the same as a regular Cub, 5 1/2". I'm sure you will want to mount the gearbox so the offset is as far as possible to the right. You may have to add an elbow to the vent.