Govener rod to carb

Mon Mar 08, 2004 1:36 pm

Hi All
The rod that goes to my carb from the govener keeps falling out, and I was wondering what is missing there if anything to hold it in. The choke rod has a fastener on the back that looks like what Mr. Willer was making for the choke rods. THANKS PAUL K. in N.H.

Mon Mar 08, 2004 1:57 pm

There is a smll hole in the end of the rod, that should have a small cotter key in it to keep it from falling out of the bracket.

Mon Mar 08, 2004 1:58 pm

The rod has a small hole in it for a cotter pin. I also put a small flat washer on the rod to keep the pin from get hung up on the linkage.

Donny

Mon Mar 08, 2004 5:31 pm

Hi All

THANK YOU John and Donny. I just checked that out with a drop light and I see the little hole, and will go with a little washer and a cotter key. THANKS again !! PAUL K. in N.H.