Farmall Cub Forum -- Questions and answers to all of your Cub related issues.
Moderator: Team Cub
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
4 posts • Page 1 of 1
My rear seal on the engine has started pouring oil and I'm looking for a little advice on replacement. My I &T manual was stolen last year so I'm working on memory untill I get a new one. I have the tools to do the job, my question is about the parts. I seem to remember something about a old and new style seal and a retainer plate. Are they interchangable or must I tear it down to see what I have? Also is there an aftermarket supplier for these items or are they dealer only? Any advice would be helpful. Thanks
The earlier seals were a few tousands larger o.d. than the later ones. Unfortunately the only ones available are the later ones. There was just enough difference that if you replaced an older one with the new one, it would spin in the retainer with a little use, and leak. Unfortunatley the newer one is all that is now available. When replacing the older one you can either buy a new retainer for aobut $100 or you can use some loctite, or jbweld, or a similiar sealer to hold it. The seal part number is 364692R91. Most auto parts stores can cross it to the brands they handle.
"The Constitution is not an instrument for the government
to restrain the people, it is an instrument for the people to restrain the
government lest it come to dominate our lives and interests." Patrick Henry
I would recommend and I think pretty well most of the board members would agree, that you should visit Binder Books and order these three manuals:
TC-37F Parts Manual
GSS-1411 Service Manual
They are basic must haves. Until you have your own to peruse at your leisure, these manuals are already online at the Cub Manuals
The I&T Manual has some good info in it as well, but the GSS-1411 is far more detailed. Also, the I&T Manual is on the site as well.
Sure hope this will help you a bit..
Hello everyone. I've only just registered for this board and while scrolling through the topics, noticed someone asking about the new rear engine seals. I was told that one had to buy the new retainer plate to hold the new version of the seal. The new retainer plate at my IH daler was $128 and the seal was $16. I bought a slightly larger OD metal seal and had the machine shop bore the retainer plate to accomodate the seal. Total cost $36 and everything fit good. Just thought I would pass that along. This is a great site for practical information!
4 posts • Page 1 of 1
Who is online