Need help with seal install
Moderator: Team Cub
6 posts
• Page 1 of 1
Need help with seal install
by Daniel H. » Thu Mar 11, 2004 9:34 pm
I'm installing the govenor seal in the crankcase and I am not clear on the instructions. Should the side of the seal with the spring be to the govenor or the distributor?
The four most expensive words in tractor restoration: "We might as well..."
- Daniel H.
- 501 Club
- Posts: 543
- Joined: Mon Feb 03, 2003 1:18 pm
- Location: NC, Yadkinville
-
Jim Hudson - 501 Club
- Posts: 1223
- Joined: Sun Feb 02, 2003 1:11 pm
- Location: Albemarle, North Carolina 28001
- Zip Code: 28001
by Cub-Bud » Thu Mar 11, 2004 10:10 pm
The spring should be toward the distributor. The open side of the seal faces the governor. The governor has a gasket between it and the block to keep oil from leaking out. The seal keeps oil away from the distributor.
"Never forget where it is you come from, or you may find yourself someplace you don't want to be"
Greg Norman
Greg Norman
-
Cub-Bud - Team Cub
- Posts: 3201
- Joined: Sun Feb 02, 2003 6:30 pm
- Location: MS, Pope
- Zip Code: 38658
- eBay ID: Cub-Bud
- Circle of Safety: Y
Oil Seals
by Bill V in Md » Fri Mar 12, 2004 7:47 am
Attached is a good article on oil seals. As Donny said, spring should face governor.........Bill V.
http://www.lidering.com/catal/Oil%20Seals.pdf
http://www.lidering.com/catal/Oil%20Seals.pdf
Bill VanHooser
1948 Cub w/ snowplow
1948 Cub w/ snowplow
-
Bill V in Md - Cub Star!!
- Posts: 493
- Joined: Sun Feb 02, 2003 6:51 pm
- Location: MD, Catonsville
- Zip Code: 21228
- Circle of Safety: Y
6 posts
• Page 1 of 1
Who is online
Users browsing this forum: bob in CT, Papa's Cub, PVF1799, Xperimental and 5 guests
|
|