Farmall Cub Forum -- Questions and answers to all of your Cub related issues.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Sat Mar 13, 2004 7:15 pm
I located a used front engine timing cover (48 Cub) to replace my old one that has a broken/welded bracket for the radiator fan. However, the replacement cover is missing the timing pointer. How hard will it be to remove the one on my old cover and press it into the replacement cover? Bill V.
Sat Mar 13, 2004 7:57 pm
They are just pressed in, though sometimes pretty tight. I had to remove the one on the 49 cub that Cub-bud is refurbishing for me to get my bearing seperator on the pulley to remove it. I just put a big pair of vice grips on it and twisted it back and forth while pulling out. Took a little effort, but came right out. Bud and Russ are going to have to worry aobut reinstalling it.
Sat Mar 13, 2004 7:59 pm
I broke one off last year,(using John method) with the timing cover off and supported it drove Right out from the backside ,go slow and good luck
Sat Mar 13, 2004 9:43 pm
"Bud and Russ are going to have to worry aobut reinstalling it".
They go back in easier than they come out, you just have to remember to put it in BEFORE installing the crank pulley.
Sun Mar 14, 2004 9:55 am
Hea Dogman; Did you get that one I sent you last year? Never did here" Jack'
Sun Mar 14, 2004 11:57 am
Yes I did Jack and thank you very much I though I replied on the the broad, but I have CRS (can't remember S#%*)
so i probably spaced it in my enthusiasm to get back to gather. it ran for about 2 week and started knocking so I had to tear it down to rebuilt it
Thank again cause i really enjoy this tractor
you are a gentleman and a scholar
Sun Mar 14, 2004 12:16 pm
Dogman, You mayhave and my Oldtimers may have kicked in "Jack"
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.