The nub on this PTO lever is sheared in half just like the pic on TM's web site. I'm thinking I can make a new nub by turning a shoulder on a piece of round stock then press out the old one and replace it with my newly turned piece. I am wondering if it will wiggle out and cause trouble?
thanks!
Stanley
PTO shifter lever repair
Moderator: Team Cub
5 posts
• Page 1 of 1
PTO shifter lever repair
by farmer.boy » Mon Mar 15, 2004 11:51 am
- farmer.boy
- Cub Star
- Posts: 66
- Joined: Tue Apr 29, 2003 10:18 am
- Location: Al, Huntsville
by Bigdog » Mon Mar 15, 2004 11:53 am
That stub is hardened steel. If you make one, you can use an old drill bit shank and weld it in. Good used replacements are available reasonably priced.
Bigdog
If you can't fix it with a hammer, you've got an electrical problem.
My wife says I don't listen to her. - - - - - - - - Or something like that!
http://www.cubtug.com
If you can't fix it with a hammer, you've got an electrical problem.
My wife says I don't listen to her. - - - - - - - - Or something like that!
http://www.cubtug.com
-
Bigdog - Team Cub
- Posts: 23786
- Joined: Sun Feb 02, 2003 12:50 pm
- Location: OH, Stoutsville
- Zip Code: 43154
- Circle of Safety: Y
by Oscar Meier » Mon Mar 15, 2004 2:01 pm
I just got one from Wenger's last summer and it was about $20.00
48 CUB & 52 Super A
- Oscar Meier
- Cub Star!
- Posts: 237
- Joined: Wed Jul 09, 2003 11:03 am
- Location: Danville, Indiana
by Peter S » Thu Mar 18, 2004 12:05 pm
When I repaired mine, I used the non threaded portion of a socket head cap screw and had it welded in place. Its been working fine for two years.
Peter
1951 Cub, 1963 Cub
1951 Cub, 1963 Cub
-
Peter S - Posts: 47
- Joined: Fri Jul 18, 2003 11:24 am
- Location: Massachusetts, Westfield
- Zip Code: 01085
- Tractors Owned: 1951 cub
1963 cub
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: calcub, Donegal Cub and 10 guests
|
|