Farmall Cub Forum -- Questions and answers to all of your Cub related issues.
Moderator: Team Cub
5 posts • Page 1 of 1
Last year was my first year of having my cub mow. In the fall last year it seemed to loose power. I thought I would just tune her up this spring and the power would be back. Well I checked the points clean not pitted and at the proper gap. Spark plugs are burning white. cap and rotor are in good shape and timming was on. I remember reading about the govener rockshaft and JB weld or lock tight. My question. How much turning play should there be between number 30 and 8? I'm thinking my key number 6 is worn or has worn number 8. The play may be preventing the lower rpm from opening up the throtle as full as it should. Is there a message / link that describes the repar/fix. Can I do this repair w/out removing the govener? I just need to budget my time when I do this repair. If I got to take off the govener I would like to take off the front of the tractor so that I can see what I am doing. As many of you cubbers know this will turn into a even bigger snowball. While I have the front off of the tractor it's time for me to buy a bearing spliter and take a wack at that front engine seal. And So on and so on. One small worn key may turn into a major all out repair project. Who knows by the end of it I may be buying another cub to mow with while I repair the one I have. It's so addictive. Thanks for your help in advance.
Wiz "Beware the Fury of a Patient Man"
There should be no play there. The key may be worn, but on mine it was the shaft had actually worn. The repair is easy. Disconnect the link to the carb and then remove the 2 bolts holding the bracket (5) at the left side of the engine. The rockshaft will then slide out to the left. Use a cotton swab or something similiar with some solvent to clean the inside of the fitting -8. If the shaft is badly worn make a bushing from shim stock (mine is made from an aluminum can). Put of drop of Loctite or JB weld on the shaft and reinsert it. I prefer using the medium strenght Loctite to JB Weld since if I need to remove it someday it is easier to do. Let it cure for a while before testing or using it.
"The Constitution is not an instrument for the government
to restrain the people, it is an instrument for the people to restrain the
government lest it come to dominate our lives and interests." Patrick Henry
My LoBoy had so much play in the rockshaft that the throttle could go from closed to full open without moving the governor spring. It wouldn't go up an incline in any gear except first. Running a mower? No way!
I used JB Weld to fix mine because of the severe wear to all the components. Along with a carburetor rebuild, what an incredible difference in performance!
Go to the manual server. Carl's article on carbs has just been uploaded. It should answer a lot of questions.
[url=http://www.cleancomputes.com/Cub/Maintenance%20Tips%20and%20Techniques/Lurker%20Carl's%20Cub%20Carb%20Fixes/index.html"]Lurker Carl's Cub Carb Fixes[/url]
Confusion breeds Discussion which breeds Knowledge which breeds Confidence which breeds Friendship
"Before beginning a hunt, it is wise to ask someone what you are looking for before you begin looking for it." - Winnie
Cub Manual Server
5 posts • Page 1 of 1
Who is online
Users browsing this forum: Arthur Luke and 6 guests