Farmall Cub

by **Paul_NJ** » Mon May 10, 2004 5:12 pm

Can I get into trouble (such as losing a setting, etc) by removing the governor to degrease and clean prior to painting, ? I've got everything off but that, but I noticed one of the two bolts (from the radiator side) is wired (looks like a factory original) to another bolt. That suggests to me to stay away from it. But it would make cleanup easier.

Just thought I'd ask. Thanks

Paul

by **ericmat** » Mon May 10, 2004 8:52 pm

Go ahead and take the gov. off just dont take out the screw with the safty wire on it or you will have to reset it
Which isnt to hard just use a dwell meter and tack to reset it

by **Paul_NJ** » Mon May 10, 2004 8:58 pm

Thanks, I'll try that

by **Donny M** » Mon May 10, 2004 9:04 pm

Paul,
You should be careful about the timing :!:

by **Jeff** » Mon May 10, 2004 10:01 pm

Whoa Paul,
You better take Donny's advice and do alittle investigating before putting a wrench on it. Check out Rudi's web site for information :!:

Farmall Cub

Removing Governor

Removing Governor

Share On:

Who is online