Final Drive/Axle Question
Posted: Sat May 15, 2004 9:41 pm
Hi All,
Need a little help.
Do you add or remove shims Gp 07/pg 11/item 24 in the IH parts book to
make the final drive gear fit tighter on the axle?
By tighter, I mean the spacing between the two cone bearings on either
side of the axle.
Thanks,
Need a little help.
Do you add or remove shims Gp 07/pg 11/item 24 in the IH parts book to
make the final drive gear fit tighter on the axle?
By tighter, I mean the spacing between the two cone bearings on either
side of the axle.
Thanks,