Fri Jun 25, 2004 10:08 am
My throwout bearing looks like it is made of graphite and has a small chip out of the side(about 1/8 inch into the surface area). Is this safe to run or should it be changed.
There is a grease zerk on the bottom of the bearing, should the bearing spin????
Fri Jun 25, 2004 11:26 am
I don't think you need to worry about the chip. The graphite bearing does not spin.
Fri Jun 25, 2004 1:00 pm
Also make sure you grease the fitting you mentioned. The graphite bearing soaks up the grease and that is what keeps it lubricated.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.