Ralph:
My son said he could use microsoft word and add the deminisions to the photo and a discription of materials. Then I can post it that way.
That would be excellent! Let me know when it is ready. I can host it on the server as well if that would be agreeable to you.
As to the question of using a varible of the unit on a standard cub I think it should be fairly easy. You would have to engineer a hinge assy. to bolt to the drawbar and could use a chain to lift with or if you want down pressure make a link out of angle or pipe to go from the rear lift arm down to the grader.
K, think I can probably figure that out. With a little tinkering it should be simple enough to construct.
I used the implement today to backfill a trench today for an electric service the ditch was about 200 ft. long took about 15 minutes.
Since it was about 90 degrees here today and it would have taken 3+ hours with the old D-1 (Shovel) I opted to play with the Cub.
It sure is rewarding when one can take his own design, build it and actually work with it. Well done.
I think you made a good choice. Cub on one hand, D1 shovel on the other - hhmmmmmm - real hard choice there
Cub it is!
Glad you had an enjoyable day too