Cable Color Codes??

Sat Aug 14, 2004 2:56 pm

I bought a 7 wire harness from Case IH for 49-1. 5 wires go back to the dash panel. They are, green, purple, gray, black, and brown. The other end of the purple splits and goes to the head lights. The brown wire goes to the starter and is connected to the ammeter. The black wire is (I assume) for the mag ground switch. That leaves the green and the gray. I know, one will go from the bat. on the regulator to the other side of the ammeter. And one will go from the F term on the generater to the resistor on the switch. I think the green would go to the ammeter but I'm not sure. It really doesn't matter but...If anyone knows for sure it would be a help. :D :D :D

Sat Aug 14, 2004 3:26 pm

Donny, here is the code from the manual.

Image

Sat Aug 14, 2004 3:47 pm

Thanks Bigdog,

It just so happens I have that manual in my hot little hands right now. :oops: :oops: I never even thought to look. :oops: :oops:

Mon Aug 16, 2004 9:01 pm

Hey Donny,

I was taught in the first training school I went to, "when all else fails,
READ the instructions/Practice". :lol: :lol:

I am sorry, just had to come back with that one. Why run backwards ye
varmint. Bet you know what that is, don't ya? Or Bonnie Brown ran over
yonder green valley while Gaylord slept.

Mon Aug 16, 2004 9:10 pm

Russ,

How about:
Bad boys rape our young girls but voilet gives willingly :?: :?:

Mon Aug 16, 2004 9:25 pm

Those would be the resistor color codes.... Like I could remember too much about what I learned in 1976! But having been a Navy school, we learned both.