Rod bearing question

Farmall Cub Forum -- Questions and answers to all of your Cub related issues.

Moderator: Team Cub

Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
User avatar
F-I-T
10+ Years
10+ Years
Posts: 42
Joined: Sat Jul 10, 2004 9:31 pm
Location: Tallahassee, FL

Rod bearing question

Postby F-I-T » Fri Nov 05, 2004 10:38 pm

Taking the crankshaft to the machine shop tomorrow for the regrind. This crankshaft came from a stuck engine, and there is a fair bit of out of round, cross taper, and general gouging and lines.

I've miked the main and rod journals, and while the mains will be fine at a .010" undergrind, one rod journal might be close. 010" under are the only rod bearings I have found so far. Looking for suggestions in case anyone knows of a source for .020" rod inserts. Otherwise, I'll have it ground to .010 under and take a look. I'd hate to have to spray it up to get to .010" under! :shock:
Frank-in-Tallahassee
'56 JD 70D // '90 JD 855 // '50 Case VAC // '48 IHC Cub "Boo-Boo" // '41 JD "H"
http://www.fboerger.com
F-I-T's webpage.....ALWAYS under construction !!!

User avatar
John *.?-!.* cub owner
Team Cub Guide
Team Cub Guide
Posts: 21527
Joined: Sun Feb 02, 2003 2:09 pm
Zip Code: 63664
Tractors Owned: 47, 48, 49 cub plus Wagner loader & other attachments. 41 Farmall H.
Location: Mo, Potosi

Postby John *.?-!.* cub owner » Fri Nov 05, 2004 10:46 pm

Check with the machine shop, he may have a source.
If you are not part of the solution,
you are part of the problem!!!

Ron
10+ Years
10+ Years
Posts: 80
Joined: Sat Feb 08, 2003 11:23 am
Location: Columbus, Georgia

Postby Ron » Sat Nov 06, 2004 8:10 am

Frank,

When I overhauled my engine the crank had already been turned .010.
It was then turned to .020 and I got the .020 bearings from my Case I/H dealer without any problem.

I believe the bearings are listed as part# 376 606 R11 for the .020.

Ron
1951 Farmall Cub

User avatar
F-I-T
10+ Years
10+ Years
Posts: 42
Joined: Sat Jul 10, 2004 9:31 pm
Location: Tallahassee, FL

Postby F-I-T » Sat Nov 06, 2004 9:11 am

Well, I looked a bit farther and this site says they have STD, .002, .010, .020, and .030, Rods, and Mains, so I shouldn't have a problem getting a set.

Thanks!

http://www.trustytractor.com/trustytractor/c60enbese.html
Frank-in-Tallahassee

'56 JD 70D // '90 JD 855 // '50 Case VAC // '48 IHC Cub "Boo-Boo" // '41 JD "H"

http://www.fboerger.com

F-I-T's webpage.....ALWAYS under construction !!!


Return to “Farmall Cub”

Who is online

Users browsing this forum: No registered users and 4 guests