Fri Nov 12, 2004 11:04 am
I have broken one of the pulleys on the back of my mower. The ones which change the direction of the belt and guide it toward the mower blade pulley. I am having a problem finding them. Could someone give me a clue as to a good source for drive belt pulleys for the cub. Thanks
Fri Nov 12, 2004 12:14 pm
Those idler pulleys are pretty generic. You should be able to find them about anywhere. Ii don't think there is much difference between Woods and IH pulleys so take the old one to any dealer who sells Wood's mowers and they should be able to match it up. A slight difference in diameter will not make any difference as long as the pulley width is correct.
Fri Nov 12, 2004 9:27 pm
Mine was riveted together so I took it apart and got the bearing number and ordered 2 new one's on line and got rivets from McMaster-Carr on line also. Work fine the last 2 summers. Much cheaper too!
Fri Nov 12, 2004 9:58 pm
I have done the samething, except rather than using rivets I used stove boltas with nuts then headed them like a rivet.
Fri Nov 12, 2004 10:10 pm
But you risk getting a citation from the correct Police. I don't go near them.
Fri Nov 12, 2004 10:30 pm
Correct police only seem to be concerned with Farmalls, not Motts.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.