How to Replace Carburator Inlet Screen
Sat Mar 26, 2011 10:08 am
Working on an IH carb from a 52 Cub and was wondering about the recommended way of replacing the inlet screen. What's the least destructive way to remove the old screen and install a new one?
Thanks.
Thanks.
Re: How to Replace Carburator Inlet Screen
Sat Mar 26, 2011 10:12 am
Push the old one out from the inside of the fuel inlet with the short end of a small Allen wrench. Then, push the new one in with the eraser end of a pencil.
Whoops, forgot to tell you to remove the needle and seat first.
Whoops, forgot to tell you to remove the needle and seat first.
Re: How to Replace Carburator Inlet Screen
Sat Mar 26, 2011 3:21 pm
And that one has just became the Cub Tip of the Week! March 26th, 2011