Removing output shaft pilot bearing (bushing)
Posted: Sun Jul 24, 2011 7:17 pm
As a first-timer, I read this forum for how to extract the brass pilot bushing. Since I didn't have a 3/4 tap, as suggested, I tried a different approach and it worked.
I had an automotive bodywork dent puller. It is a slide hammer wiTh a threaded end. I found a mating bolt, connected it with a nut, and with only very slight grinding of the bolt hex head corners it slipped right into the bushing. I just caught the backup edge of the bushing with the bolt head (moving it around a bit) and pulled it right out with just a few hammers. Might not work for one really stuck, but worked for me.
I had an automotive bodywork dent puller. It is a slide hammer wiTh a threaded end. I found a mating bolt, connected it with a nut, and with only very slight grinding of the bolt hex head corners it slipped right into the bushing. I just caught the backup edge of the bushing with the bolt head (moving it around a bit) and pulled it right out with just a few hammers. Might not work for one really stuck, but worked for me.