Hi all,I'm putting a new oil seal on the steering shaft. I looked up the part # in the parts manual on Rudi's site, it say's I need # 350 892 R91. The list on the FAQ sheet say's part # is 385 703 r92, and the original seal that I took out of it is # 358 837 R91. Does anyone know which # I need for the seal? I'm going to use either the CR brand or a National.
Mike
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Oil Seal #
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- 10+ Years
- Posts: 145
- Joined: Mon Feb 02, 2004 7:05 pm
- Location: Brookfield Nova Scotia
Oil Seal #
My dad once told me if it wasn't for bad luck......I wouldn't have any luck at all......
-
- 10+ Years
- Posts: 145
- Joined: Mon Feb 02, 2004 7:05 pm
- Location: Brookfield Nova Scotia
Yes I Seen that on the FAQ list. That Part # that matches up with cr 8677 is 385 703 R92. The # that came out of mine is 358 837 R91. Will this matter at all? Donny, did you use CR 8677? Was it a good fit? Did anyone else put in a new steering shaft oil seal?
My dad once told me if it wasn't for bad luck......I wouldn't have any luck at all......
-
- Team Cub Guide
- Posts: 3543
- Joined: Sun Feb 02, 2003 6:30 pm
- Zip Code: 38658
- eBay ID: Cub-Bud
- Tractors Owned: Four FCUBs, one IH Lo-Boy, one B Farmall, two Cadets, and a John Deere B.
- Circle of Safety: Y
- Location: MS, Pope
-
- 10+ Years
Who is online
Users browsing this forum: No registered users and 25 guests