Mon Dec 02, 2013 1:25 pm
Littlecub, Tim Talleur (tst) is the only one I know of that is refitting the rear main seal now. You can PM him (private message) or I think he has an ad under the Classified for services available. Also, welcome to the Forum.
Last edited by Bob McCarty on Mon Dec 02, 2013 5:05 pm, edited 1 time in total.
Mon Dec 02, 2013 2:12 pm
Thanks ill try him. It's nice to have people that still now about the cool stuff thanks again
Mon Dec 02, 2013 7:28 pm
I happened to be looking at the TM Tractor site last night after being arms into my Cub, wanted to see what was new there....if I read it correctly, they have a rear seal and rubber grommet that only fits the new rear seal retainer they sell. I am sure the folks rebuilding them here on the forum are equal or greater quality, just givin' you another possible option.
Mon Dec 02, 2013 8:08 pm
with all the adhesives out there, why wouldn't that work? i had an tav that had loose fitting wheel bearing in the front spindles and the factory fix was to use a lactate adhesive on them. it worked for many years without a problem.
Tue Dec 03, 2013 8:48 am
I would love to find a cheap fix for it like adhesive. I checked tm website. I will cost over 200$ for the seal retainer and gasket. I found Tim Talluer (tst) and he said if I send him my retainer and 47$ he will fix it and send it back to me. It's worth that to not have to pull the cub a part again. Thanks for the ideas guys. Thanks Tim I'm mailing it to you today!!
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.