Farmall Cub Forum -- Questions and answers to all of your Cub related issues.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Sat May 05, 2012 7:01 am
Do you time the engine without a mag just lime there was a mag.
Sat May 05, 2012 7:19 am
Please restate or explain your question. Honestly, I do not know what information you are looking for.
Sat May 05, 2012 8:02 am
If you are referring to a battery ignition (distributor) unit, refer to timing instructions on Pg 25-27 in the following link. It is a little different compared to timing a magneto.http://www.cleancomputes.com/Cub/Cub%20Preventive%20Maintenance%20Manuals/Preventive%20Maintenance%20Manual%2011-7-58/Preventive%20Maintenance%20Manual%2011-7-58.htm
Sun May 06, 2012 1:32 pm
Thanks bill You have the same year of Cub as I do. Also have a 1947.
Sun May 06, 2012 4:33 pm
Glad Bill was able to give you the answer you needed. Might I suggest you spend a little time following these links
Sat May 12, 2012 5:30 pm
Cub not start. New plugs,points condenser dist cab, checked timing TDC will not start. what might be problem
Sat May 12, 2012 6:29 pm
Did the engine run before you did the tune up?
Did you remove the distributor from engine when you replaced the points and condensor?
How did you check the ignition timing?
Remove the coil wire from the distributor, place so distributor end is about 1/4" from engine block. Crank engine over with ignition on. Are you getting fire from the coil?
If you are getting a good hot spark, then ignition timing fault some place. Spark plug wires on wrong terminal. Ignition 180 degrees out of time. Distributor not timed to engine.
No spark from coil wire. Check to see if the lead to the condensor is not grounded to the distributor case. Common fault.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.