Farmall Cub

The 75 Cub I got a few months back has only got 2 issues. Rusty Front Rims with worn tires, and the steering has some play (about 12-2 or 3) at the steering wheel. The front tires shimmy a little bit too when traveling over rough ground or at fast speeds.

I would like to tackle the steering slop job this weekend.....or at least get it started; but since I've never messed with the steering, then I need some pointers beforehand on diagnosing the potential problem; and how to fix it. I looked in the CBoK, but didn't find anything on Steering.

(Pictures attached for Enjoyment)

I would jack up the front end of your Cub and remove the axle and steering gear housing. Check for wear on all parts and gears but more specifically items number 18 and 23. I have had worn thrust washers in the past cause the issue you describe.

But it could also just be a matter of tightening up any play on the nut and cotter key (item number 29).

Do some disassembly and let us know what you find.

Here are Rudi's schematics:

http://www.cleancomputes.com/Cub/Blue%2 ... -03-12.jpg

http://www.cleancomputes.com/Cub/Blue%2 ... -03-13.jpg

The first order of business would be to get an assistant to help you isolate where the play is coming from. Have your assistant operate the steering wheel back and forth through the "play" area while you start at the outer tie rod ends working your way in and finally examining the gearbox.

Next check and service the front wheel bearings if necessary to remove any slop from them. While it is in the air, examine the front axle pivot pin for excessive slop. Take necessary action to repair that if the fore and aft or up and down movement is excessive.

Hopefully only your tie rods and wheel bearings are causing your woes and your gear box is tight enough to give a pass with only a lube change.

Have fun!

Usually, the sloppy play will come from the steering arm area. That is the arm that sticks out front that the inboard end of the tie rods attach. If the play comes from where the tie rods attach, separate the end by removing the two bolts. There should be a double shim (s) there. The thinner the shim the less play in the tie rod ends. The other play will be an up and down motion at the rear. If play is there, remove the small bolt that acts as a clamp. Then remove the cotter key and tighten the castellation nut as tight as possible. Then back off a notch or two to allow a little play. If this does not remove most of the play, then it is time to go into the steering box. But, most of the time this is all you need to do.

Set the tie rods lengths so the toe-in is 1/4". Check your manual for this procedure.

Thank you all for the great information. Boss Hog called me last night also and gave me your tips exactly Big Hoss. I'm gonna try it this weekend if the weather holds up!

Now all I need to do is get me 2 good front rims and some new front tires and I'll be set!