Switch to full style
Farmall Cub Forum -- Questions and answers to all of your Cub related issues.

Forum rules

Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Post a reply

Cub Steering Box Parts

Wed Oct 24, 2012 4:19 pm

Is there any other source other than TM Tractor & CIH for the steering bushings (upper and lower) and the thrust washers for the Farmall Cub steering box? I would like to rebuild the steering on several Cubs without breaking the bank. Looks to be around $150 plus shipping to do each one (just the bushings, seals, and thrust washers).

Seems to me that the small bushings and thrust washers could be made by a machine shop if someone had the proper dimensions. I have access to a machinist and would like to have several parts made if possible.
Last edited by AL Farmall Boy on Wed Oct 24, 2012 4:34 pm, edited 1 time in total.

Re: Cun Steering Box Parts

Wed Oct 24, 2012 4:24 pm

for the top bushing, I take a 1" copper pipe end cap, grind or cut the top off. Then cut through the side wall with a hacksaw. Champher the bottom edge first, so that the gear will slide into it

Re: Cub Steering Box Parts

Wed Oct 24, 2012 4:41 pm

The issue with using copper for these parts is its much softer and will wear much faster than the bronze that is supposed to be there.

Re: Cub Steering Box Parts

Wed Oct 24, 2012 4:57 pm

I understand Raymond, you are spot on.

However--(don't you love "howevers"?) Most of today's cubs get little work, compared to when they were built 60 years ago. If the bronze worked well for the first 60 with heavy use, most of them will last forever with this repair with the limited use the majority of our cubs get with the technology of today's lubricants.

Re: Cub Steering Box Parts

Wed Oct 24, 2012 8:14 pm

I try not to buy cubs with bad bushings :D

Re: Cub Steering Box Parts

Thu Oct 25, 2012 9:30 am

Yeah.....those little things (for what they are) are priced like gold! I just figgered there might be a universal source, or someone might have the schematics and dimensions to have some made up by a machinist.....which I have access to without it breaking the bank.

Re: Cub Steering Box Parts

Sun Oct 28, 2012 8:16 pm

If you were to buy one set of bushings and thrust washers you would have the dimensions to make more. Just a thought. Good Luck! Hope all goes well for you. Frank

Re: Cub Steering Box Parts

Sun Nov 04, 2012 2:12 pm

That is exactly what I've done frank. Thanks for the tips guys.
Post a reply