Page 2 of 2

Re: Transmission Inspection

Posted: Tue Nov 13, 2012 10:06 pm
by indy61
It's probably the input shaft bearing. Unless the noise gets worse, don't worry about it. Fix it next time you split it. Mine's been that way for years and I work it hard.

Re: Transmission Inspection

Posted: Wed Nov 14, 2012 9:59 am
by cub47
indy61 wrote:It's probably the input shaft bearing. Unless the noise gets worse, don't worry about it. Fix it next time you split it. Mine's been that way for years and I work it hard.


Not likely the cause, if it was, he would be getting similar noises in all gears.

Re: Transmission Inspection

Posted: Fri Nov 16, 2012 3:00 am
by Bill E Bob
Had a clicking transmission, checked everything-wheel bolts, nuts etc-no luck :( Finally found a cracked reverse idler gear-replaced it and all was well :D (BTW, took me 3 transmission tear downs to find it :evil: )

Re: Transmission Inspection

Posted: Fri Nov 16, 2012 5:56 am
by coppersmythe
i would have never thought to look for a crack, thanks for the info bill e bob. one more arrow in my quiver. :wink: coppersmythe............................................

Re: Transmission Inspection

Posted: Sun Dec 09, 2012 5:35 pm
by SC288
I am helping my Grandfather with his 66' Cub....we confirmed that it has a missing tooth on the reverse idler gear yesterday and know that we have to split the tractor to change it. We have the manual with directions on how to split the tractor etc. but I was wondering after the tractor is split if someone had step by step instructions on how to change the reverse idler gear? Also what type of gear oil is used and what capacity does the transmission hold? Thanks in advance for you help on this!

Re: Transmission Inspection

Posted: Sun Dec 09, 2012 8:49 pm
by cub47
SC288 wrote:I am helping my Grandfather with his 66' Cub....we confirmed that it has a missing tooth on the reverse idler gear yesterday and know that we have to split the tractor to change it. We have the manual with directions on how to split the tractor etc. but I was wondering after the tractor is split if someone had step by step instructions on how to change the reverse idler gear? Also what type of gear oil is used and what capacity does the transmission hold? Thanks in advance for you help on this!


Use 8090W gear oil in your transmission.

Remove the small level plug on the left-lower side of the transmission housing as shown in the top photo here:

http://www.tm-tractor.com/gtr/case_001.htm

Fill the housing with gear oil until you see a flow of oil coming out of this check level plug. Reinstall this check level plug along with the fill plug on the top of the transmission housing and you are good to go.

Locations and How-to's:

viewtopic.php?f=141&t=47391

http://www.tm-tractor.com/gtr/locations_001.htm

Re: Transmission Inspection

Posted: Sun Dec 09, 2012 10:31 pm
by CharlieK
don't know 'bout step by step instructions but just have at it and if ye get stumped ya can get answers here