c-3 spindle question

[Rob in NH]

i had to take the pulley off the center spindle and forgot that the center sheave is split, are these still available?

[tst]

Hi Rob, yes they are available through the dealers, also I see Hamiliton Bob now has repops for these
Tim

[Rob in NH]

thanks tim, now my next question,the reason why i took it off was because of the bearings have gone bad, would anyone have the numbers for the bearings and seals?

[lombard]

BOB IN N.H.

WHEN YOU START TO PUT IT BASK TOGETHER BE SURE THE TOP SEAL HOLDS
GREASE IN BOTTOM SEAL HOLDS DIRT OUT AND LETS GREASE OUT--------FILL IT
FULL OF GREASE WHEN PUTTING IT BACK-------WITH ONLY ONE GREASE FITTING
TO WORK GREASE THROUGH TO BOTTOM BEARING-----YOU CAN STILL USE THE
SPLIT HUB AS LONG AS YOU HAVE A BOLT IN EACH PEACE----


GOOD LUCK
LOMBARD----SC---
MY $0.08---

[Buzzard Wing]

You may be able to cross the bearings with the IH part numbers. I would guess that they are Timken tapered roller bearings with CR or National seals. The numbers may be on the parts.

Or just call C&G.

http://partstore.caseih.com/us/parts-se ... :mr02-1092

[Buzzard Wing]

Looks like my favorite parts guy already answered the question.... (found it searching for the IH seal part number)

viewtopic.php?f=1&t=16239

[Rob in NH]

thanks larry, thats what i needed