Farmall Cub

Barnyard wrote:I don't know if what I found on that page are the rtight ones. I just thought it would be good to share the number with others who may want to do this in the future.

I am finally on a computer instead of the smartphone!

The part numbers are right, however, I was only charged $7.67 for the pack of 25. Not sure why...but I surely dont mind!

Still not a bad price though when you figure you're getting 25 of them. If you want I can unlock your post in the how to forum and add the part number so it won't be lost.

Barnyard wrote:Still not a bad price though when you figure you're getting 25 of them. If you want I can unlock your post in the how to forum and add the part number so it won't be lost.

That would be great! Thanks!

Here they are finished, and done quite well. You can see why I used the services of a welder, as I am a "bubble gum" welder...

If you want to add that last part into the How To I will unlock it for you.

Thanks Clodhopper. Great tip.

Barnyard wrote:If you want to add that last part into the How To I will unlock it for you.

OK.

clodhopper wrote:

Barnyard wrote:If you want to add that last part into the How To I will unlock it for you.

OK.

PM sent.

Got to try em out today...can you say power steering? The difference is amazing. Thanks for making this a how to Barnyard. I hope it can help someone out.

clodhopper wrote:Thanks for making this a how to Barnyard. I hope it can help someone out.

You made it a How To. I just did the easy part by copying it. I'm sure somebody else will use it.

Barnyard wrote:

clodhopper wrote:... I'm sure somebody else will use it.

I will be ordering a bag of those puppies, just to have on the shelf, because I'm sure to need them.

Great information on the tie rods.I need to do the same with my tie rods! Thanks