Farmall Cub Forum -- Questions and answers to all of your Cub related issues.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Tue Dec 11, 2012 12:41 pm
5/16" - 18 thread with 1/2" hex head cap screw, per parts book.
Tue Dec 11, 2012 1:35 pm
I have never had a problem removing or replacing the bolt some times you will have to take the coil off , but a short 1/2 in boxed end wrench works fine for me. I do not like to leave it off and will replace it if it is missing.
Tue Dec 11, 2012 1:36 pm
bythepond88 wrote:That should be a 1/2" bolt.
Just to clear up any confusion here... The correct size bolt is 5/16. That bolt takes a 1/2 inch wrench.
Tue Dec 11, 2012 1:42 pm
Do you needs some Don?
Tue Dec 11, 2012 2:15 pm
I have been using the same wrench shown by Eugene for many years, that is the only wrench that works for me. and I don not reinstall the back bolt when I remove it now.
Tue Dec 11, 2012 4:40 pm
Boss Hog wrote:Do you needs some Don?
The bolt or the clamp?
No to either. I just didn't want someone throwing them in the trash.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.