Page 1 of 1
Cub magneto
Posted: Sat Dec 29, 2012 12:14 pm
by wmatthewb
The rotor in the magneto suddenly stopped turning what could be wrong/broke in the mag to keep rotor from turning
Re: Cub magneto
Posted: Sat Dec 29, 2012 2:22 pm
by RaymondDurban
Could be the pinion gear or the rotor itself. Have you took them off and looked at them?
Re: Cub magneto
Posted: Sat Dec 29, 2012 2:45 pm
by wmatthewb
Yes we took the rotor out and looked at the 2 gears behind that but don't see anything else that's visible, when you turn over the motor the rotor doesn't turn, and when I parked it a week ago it was running fine..
Re: Cub magneto
Posted: Sat Dec 29, 2012 3:02 pm
by RaymondDurban
With the rotor and pinion removed, does the shaft that the pinion mounts on turn when the engine is turned? Can you hear a "click" in the Mag when the engine is turned?
Re: Cub magneto
Posted: Sat Dec 29, 2012 9:49 pm
by John *.?-!.* cub owner
Look at the gear on the back of the rotor. Most likely it has some teeth stripped. If not check that the teeth on the drive gear (pinion gear) are mot worn off. Another question is are the points opening and closing?
Re: Cub magneto
Posted: Sun Dec 30, 2012 10:37 am
by Rudi
wmatthewb:
The
GSS-5035 Service Manual Magnetos should be of some help as well.
Re: Cub magneto
Posted: Tue Jan 01, 2013 9:23 pm
by wmatthewb
Removed mag today to revel springs,broken teeth etc falling out the front of the mag
Re: Cub magneto
Posted: Wed Jan 02, 2013 10:50 am
by John *.?-!.* cub owner
wmatthewb wrote:Removed mag today to revel springs,broken teeth etc falling out the front of the mag
how about some pictures? Maybe we can help with parts or advice.
Re: Cub magneto
Posted: Wed Jan 02, 2013 6:28 pm
by Rick Spivey
PM sent with explanation. Be sure we have a magneto and not a distributor.