Farmall Cub Forum -- Questions and answers to all of your Cub related issues.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Thu Jan 03, 2013 4:57 pm
Me again guys getting closer to replacing the large gasket btwn the upper and lower steering housing. Do you recommend any type of sealer on the gasket. Sure want to make sure this thing is done right. Thanks again Dan
Thu Jan 03, 2013 5:42 pm
I didn't put any on my Cub or Farmall 140, and so far they are holding fine with no leaks. I would assume that the original way from the factory (gasket) should be the best way to go, as that's the way they engineered it. Maybe some others will chime in to give some feedback on their expierences.
Thu Jan 03, 2013 6:05 pm
Whatever you use (or don't), make sure you clean out the plug in the fill port. There is a small hole in one of the square sides of the plug for a vent. If its plugged up, the heat from the radiator will expand the oil and force it out, usually along this gasket, or the lower seal.
I prefer Indian Head Varnish. Perfect for this application.
Thu Jan 03, 2013 6:11 pm
Here are the vent holes Raymond is referring to.
Thu Jan 03, 2013 6:55 pm
I didn't use any on my Lo Boy and it's held up OK with just the gasket.
My new favorite sealant is 'Hylomar'. It's non-hardening and supposed to be reusable. Will give it a good test on the engine when I finally get the tranny back together. But the oil pan and front cover have held ok so far. It is a bit hard to locate, but packaged by Permatex. Ebay or Amazon is the easiest.
Thu Jan 03, 2013 7:02 pm
i used indian head on mine too. i use the non hardening type on the cork gaskets.
Thu Jan 03, 2013 8:18 pm
Thanks guys. And the plug cleaning is on my list. While doing a search I came across the video that explained that. Who would have ever thought that can happen.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.