Farmall Cub Forum -- Questions and answers to all of your Cub related issues.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Fri Jan 11, 2013 4:15 pm
What is the diameter of the front nose of the crankshaft that the drive pulley is pressed onto?.
Fri Jan 11, 2013 9:01 pm
G'day to you
Sorry I don't have the answer to your first question as I am not exactly a mechanic
. I just looked at the GSS-1008 - Specifications
manual, but couldn't find the answer to your question. You may be able to discover the answer by conducting and Advanced Search
In any case, there are many excellent mechanics here who should be able to help. We have a lot of resources available to our members and I would suggest reading the info at the following links.
Fri Jan 11, 2013 9:05 pm
I will mic it tomorrow if you dont get an answer by them
Mon Jan 14, 2013 9:56 am
I still haven't found te answer yet. Could someone mike the diameter?
Mon Jan 14, 2013 1:46 pm
I believe it was 1.167 but will recheck it, I should have written it down
Mon Jan 14, 2013 6:09 pm
so cold in my shop I did not bother with the micrometer, but my digital caliper said 1.126
Mon Jan 14, 2013 8:55 pm
Thanks to both of you.
Boss, could you please recheck the dimension with your micrometer in order to confirm the actual dimension.
By the way, mine is a 1949 Cub. Are the cranks that you are measuring also of that same era?
Mon Jan 14, 2013 9:01 pm
What's the plan? Curious. Why do you need to know the crankshaft pulley end diameter.
Tue Jan 15, 2013 8:39 pm
Need the diameter of the crank nose in order to make a tool that will allow me to align the front cover with the O.D. of the crank nose BEFORE I install the pulley.
Tue Jan 15, 2013 9:36 pm
Okay. Why not set the gasket and front cover in place, with crankshaft front seal installed? Gently snugged up 4 or 5 bolts just enough to set the cover in place. Install the front pulley. Then loosen snugged bolts, install remainder of bolts, tighten.
Wed Jan 16, 2013 12:59 pm
I would prefer to use an alignment tool that is a nice slip fit over the end of the crank, in order to align the front cover with the seal installed.
Then, when the front cover is snugged up, press fit the pulley onto the crank.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.