Mon Jan 21, 2013 12:22 pm
I recently bought a 1952 Cub and noticed my oil pressure is all the way in the white zone of mh gouge is this normal??
Mon Jan 21, 2013 1:03 pm
Welcome to the Forum!
What weight oil are you running? Does the pressure drop at all after the engine is warmed up?
Mon Jan 21, 2013 2:19 pm
Either you have a bad gauge or the relief valve is stuck , If the pressure does not drop back some after it has wormed up.
Mon Jan 21, 2013 4:38 pm
My gauge does drop down after i shut it off,what worries me is that i dont remember it being that high when i bought the tractor. I since changed the filter and oil (30w) and its still high should i be concerned?
Mon Jan 21, 2013 5:30 pm
Easy no cost check for stuck oil pressure regulator valve. Start engine and get oil pressure up. Stop engine. Remove the cap on the oil pressure regulator, remove the spring. Replace the cap.
Start engine at low idle, observe the oil pressure gauge for 15 to 20 seconds. Stop engine. Remove the cap to the oil pressure regulator valve. If valve is now located in the back of the bore, next to the cap, valve is not stuck. Could be that the spring has been replace with a much heavier one.
In case the valve is stuck. Post back, we have a valve removal method/tool.
Although once functioning, the valves seldom stick when the tractor has been relatively frequently operated.
My guess is the fault is the oil pressure gauge.
Mon Jan 21, 2013 5:33 pm
Where is the oil pressure valve located?? sorry im new to this and my tractor, but learning quickly... pictures are helpfull to!!
Mon Jan 21, 2013 5:44 pm
Front right side of the engine, behind a "hex cap", just above the water inlet line.
Tried to final a photo that pointed it out, but had no luck.
Mon Jan 21, 2013 5:52 pm
Thanks Ray still not sure were that is,near the radiator?? sorry im not clear on were its at.
Mon Jan 21, 2013 5:58 pm
It is the hex cap on the right in this picture. (Picture from TM Tractor Parts.)
Mon Jan 21, 2013 6:03 pm
You would do well to look at the manuals, they are at the [ NEW ] Manuals link at the left top of the page.
Mon Jan 21, 2013 6:30 pm
ok great pic now i just need to locate that item and shall i try what you suggested then?
Mon Jan 21, 2013 6:46 pm
Remove that hex bolt, and behind it will be a spring. This spring pushes against a plug and is what regulates the pressure. If the plug is stuck, there will be no relief and it will cause high oil pressure.
Open it up and have a look. If its stuck and you can't get it out with a magnet on a stick, come back and we'll show you a trick to get it out and cleaned up.
Mon Jan 21, 2013 7:19 pm
Ok great so, far Im a cnc machinist so this will be fun. Love to see your trick...
Mon Jan 21, 2013 8:14 pm
If i try this and i still have high pressure is it safe to run,also if i push on this wooden dowel i will not push anything into the motor will i? Thanks for all your help if i try and it doesnt work i hope its good to drive...
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.