Farmall Cub Forum -- Questions and answers to all of your Cub related issues.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds
or one of our site sponsors for your tractor and parts needs.
Fri Jan 25, 2013 2:48 pm
Is there a diagram anywhere of the front stay chain bracket for the 193 plow? Parts manual does not show a clear pic of attachment and/or shape. Figure it w/be a reproduction in the shop. If someone has an OEM that they could snap a picture of and post it would give me an idea of where to start. Manual also doesn't show where/how it is attached - drawbar?? Thanks, Dusty B
Fri Jan 25, 2013 2:55 pm
Here you go Dusty.
Photo courtesy of TM Tractor Parts
Fri Jan 25, 2013 5:36 pm
Dusty B wrote:Manual also doesn't show where/how it is attached - drawbar?? Thanks, Dusty B
Dusty, it gets attached to your depth adjustment lever, not your drawbar.
Fri Jan 25, 2013 8:29 pm
i never knew they made 2 quadrant supports for the 193...one with a stay chain bracket and one without. Mine does not have one either. I guess I will have to make one. I have been bolting the stay chain to one of the final holes. Probably not a good idea.
Sat Jan 26, 2013 8:15 am
I've got one that has a "J" bolt in place of the stay chain keyhole bracket (Of course the hook of the 'J" is turned skyward
). Never tried it but it looks like it would work OK and it would be a whole lot easier to just drill a hole instead of trying to make the bracket and weld it on. Unless you're going for original.
Sat Jan 26, 2013 11:13 am
Dusty, is this for the plow I sold to you? I was under the impression that later 193's did not use the stay chain and therefore had no bracket welded onto the depth adjustment lever. That plow I sold you was a later model, IIRC, and had no brackets or chain provision. Perhaps Jim B. can shed some info on this correct me if I'm wrong.
Sat Jan 26, 2013 11:42 am
The chain and related parts were added in 1951.
Sat Jan 26, 2013 12:31 pm
Jim Becker wrote:The chain and related parts were added in 1951.
OK............obviously the one I had above was an earlier model.
But it was a nice one. PO had repainted it but it showed very little wear. It came from an estate auction and all his Cub implements were very well cared for.
Fri Feb 01, 2013 7:54 am
Denny - I'm not sure if this is that particular one or not - I have 2 of them. Thanks for the help tho guys, I do want to fabricate a stay chain as it is difficult to finish a land smoothly. Back to the scrap pile I guess! LOL ! Thanks again, Dusty B
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.