This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link:
Privacy Policy

NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.

Mag oil seal n stall question

The Cub Club -- Questions and answers to all of your Cub related issues.
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Criswell
10+ Years
10+ Years
Posts: 203
Joined: Thu Sep 29, 2011 3:17 pm
Zip Code: 48180
Tractors Owned: 1952 Cub with
- 54 Blade
- 193 Moldboard Plow
- Woods 59 C-2 mower

Re: Mag oil seal n stall question

Postby Criswell » Mon Feb 11, 2013 1:26 pm

Here is the "tool" that I had made to install the oil seal. First start with governor base that is worn out and past its useful life. The one pictured below has had the machined surfeace where the weight carrier rides worn down in excess of 0.040"

Image

Next, remove the oil baffle on the back of the governor base that would direct the oil inot the hole in the base/bushing. Just a couple of minutes with the bench grinder and then about 5-10 minutes with a file to clean it up. The baffle has been grond and filed flush to the back of the governor base. Removing the baffel will allow the "tool" to clear the ID of the new seal.

Image

Next, using a 2" 5/8-11 bolt, 2 jam nuts, 1 washer and some permanent Loctite (red) and you have the tool assembled and ready to go.

Image
Image

The governor base is the correct diameter and it also has a lip on it it to stop it at the proper depth. The worn out governor base was already on hand and the bolt, washer and nuts cost $1.00, so all-in-all it is a relatively cheap and easy tool to make that works very well.
Where you are, right now, is of absolutly no use unless you are able to get away from it, FAST!

SPONSOR AD

Sponsor



Sponsor
 


Return to “Farmall Cub”

Who is online

Users browsing this forum: No registered users and 21 guests