Moderator: Team Cub
Tubby Creek Farm wrote:how difficult to rebuild these starters?
lazyuniondriver wrote:Tubby Creek Farm wrote:how difficult to rebuild these starters?
If you have a mechanical skill aptitude of slightly higher than doing an automobile tune-up, changing rocker cover gaskets, and can adjust valve tappets, I would speculate you should have no difficulty doing the job. However, unless you have specialized tools, an armature growler for example, you could still wind up in the jack pot later if a component fails you neglected to test.
I second the motion of having a starter/electric shop do the work. A complete rebuild by a shop will more than likely give you another 5 decades of service.
Boss Hog wrote:I bet it aint as small as mine, surfer boy
Users browsing this forum: bibbster, Bill V in Md, Bob McCarty, Cubfriend, Ken (48 Cub) and 5 guests